XEROX 7142 DRIVER

      No Comments on XEROX 7142 DRIVER

Open the front cover. Read and understand the positions and contents thoroughly before maintenance operation. Horizontal nozzle alignment check CCW direction: To exit the self-diagnosis menu, press [Power] key. Check whether the program is properly installed from the operation panel.

Uploader: Maugore
Date Added: 1 August 2011
File Size: 42.96 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 4308
Price: Free* [*Free Regsitration Required]

Program ROM may be Update firmware. Before transporting the plotter, you must package it in the same manner as it was delivered using protective materials and packaging materials so that the plotter will not be subject to excessive impact and vibrations during the transportation. Powerful Executes main suction xerox 7142 of normal xerox 7142 with 10 times as many steps.

The available settings are shown below. However, if the cause of failure is uncertain, decide the action xerox 7142 due mutual consultation.

Xerox 7142 42″ Colour CAD Plotter

Therefore, even if a serious error occurs during endurance running, the number of finished cycles just before the occurrence of the serious error can be confirmed.

Related Drivers  HP 3000 J310 DRIVERS FOR WINDOWS MAC

Then, when the LCD displays bytes recv parameter writing completes. Then, enter the difference xerox 7142 the relevant parameters. Xerxo xerox 7142 R side cover inner screw tapping screw M4 12, P tight binding black: Part name T fence CR encoder assembly 7. Part name Ink tube Damper fixing material 9. Xerpx which Remove all cartridges “5.

To quit xerox 7142 diagnosis, press [Cancel] key in the operation panel. Head ID will be updated. Replace the power board assembly 4. Remove 7412 standard media. From the three fence guides, remove the T fences by following instructions in the xerox 7142 below. Let us wish you a happy birthday! Is working Use machine under specified “3. Move the vertical-slant adjusting tab to the left.

Check if the same If the message appears: When reassembling the unit, note the following sensor fastening torque.

Xerox MFP Specifications

Part name Tube xerox 7142 Tube clamp 3. To adjust the margins, follow the xerox 7142 below. This section describes the procedure to remove covers. Remove the tube clamps 3 points. Remove the bearer holder-retaining screw pan-head screw with spring washer and flat washer M3 2pcsthen remove the bearer holder.

Related Drivers  VIEWSONIC G810 DRIVERS DOWNLOAD

In case of main board replacement, work in the following order. Remove xerix two head tape wire from the print head.

Table of Contents Xerpx to my xerox 7142 Add. Sponsored products for you. Step 2 above is repeated the number of times specified as follows.

Xerox – Oxbow Xerox

The updated parameters will not be stored xerox 7142 the flash memory unless the system power is turned OFF as normal procedure. Remove the ink tube.

The self-diagnosis function can adjust the printing accuracy, and check the condition of each major part. Print Xerox 7142 Displays the serox number of printed copies.